PAT TESTING
When used in an office environment, this product should be safety-tested
yearly by a qualified electrician (PAT Tested).
We recommend that it is PAT tested regularly when used in a domestic
environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at
least once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring
must be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is
mandatory for new buildings).
OPERATION
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that
the lead is rated at 10 Amps or more, and that it is
fully unwound.
Switch the unit on at the mains socket.
All the following controls can be operated via the
control panel or the remote control.
Switch the unit on by pushing the On/Off button
The unit will beep to show it is powered on and
ready.
The display will show the room temperature.
To set the desired room temperature first press the Temp button
then the Plus or Minus Button to increase or decrease the
desired room temperature. Holding the Plus or Minus buttons for approx.
3s will cause the display to change at a faster rate.
Select the required heating power by pushing the Heat button then
the Plus and Minus buttons. The power options are as follows;
Eco = 750W the unit will beep once.
Comfort = 1250W the unit will beep twice.
Super = 2000W the unit will beep three times.
The fan can be operated at any time by pressing the Fan Button,
Fan Switch
Power
Switches
