Page 9
Wall mounted kit:
W1. Wall bracket x 1pc
W2. Pipe flange x 2pcs
W3. Air intake pipe (dia.120mm) x 1pc
W4. External grating (Pre-installed) x 2pcs
W5. Hot air discharge pipe (dia.130mm) x 1pc
W6. Template for wall drilling x 1pc
W7. Extension condensate hose x 1pc
W8. Screw kit: ST4*10 x 10pcs
ST5*40 x 8pcs
Nylon anchor
∅
5*40 x 8pcs
W9. Foam pad x 2pcs
(pre-installed)
W10. Rubber grating ring x 2pcs
W11. Nylon cord
** Note W9 are preinstalled in the unit for WALL MOUNT only VISION.
F. WALL MOUNTING INSTALLATION INSTRUCTIONS
1. Positioning the air conditioner
z
To obtain maximum performance
from your unit, it must be correctly
positioned. Please following the
guidelines and instructions below
in full, as failure to do so could
cause potential installation
problems:
z
The air conditioner must be
installed on an exterior wall that
has access to the outside and a
minimum of 2 meters free
clearance to allow good airflow
z
The unit must be fitted following
the template, with space to the top,
bottom and sides of the unit.
z
The wall on which the unit is
installed must be sturdy and able
to withstand the weight of the unit.
After determining the best place for installation as described above,
please check to ensure that the wall can be drilled without causing
damage to the fabric of the building. If necessary obtain professional
advice to ensure that no damage is done to power supply or water pipes.
Please also ensure that there are no obstacles on the outside of the wall
which may interfere with the performance of the unit.
Attention: Install the unit at least 1 meter
apart from ceiling to prevent air blockage
