Item 68527 / 68528
Page 2
For Pump technical questions, please call 1-800-444-3353.
For engine technical questions, please call 1-800-520-0882.
Sa
Fet
Y
O
Pe
R
ati
O
n
m
aintenan
C
e
Setu
P
table of Contents
Safety ......................................................... 2
Setup .......................................................... 6
Specifications ............................................. 6
Operation .................................................... 8
Maintenance .............................................. 14
Parts List and Diagram .............................. 20
Warranty .................................................... 23
WaRninG SYmBOlS anD DeFinitiOnS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
imPORtant SaFetY inStRuCtiOnS
inStRuCtiOnS PeRtaininG tO a RiSK OF FiRe,
eleCtRiC ShOCK, OR injuRY tO PeRSOnS
WaRninG
– When using tools, basic precautions should always be followed, including the following:
Set up Precautions
1.
Gasoline fuel and fumes are flammable,
and potentially explosive.
Use proper fuel
storage and handling procedures. Do not store
fuel or other flammable materials nearby.
2.
Have multiple ABC class fire
extinguishers nearby.
3.
Operation of this equipment may create sparks
that can start fires around dry vegetation.
A
spark arrestor may be required. The operator
should contact local fire agencies for laws or
regulations relating to fire prevention requirements.
4.
Set up and use only on a flat, level,
well-ventilated surface.
5.
all connections and conduits from the
Generator to the load must only be installed
by trained and licensed electricians, and
in compliance with all relevant local, state,
and federal electrical codes and standards,
and other regulations where applicable.
6.
Connections for standby power to a building
electrical system must be made by a qualified
electrician.
The connection must isolate the
generator power from utility power, and must comply
with all applicable laws and electrical codes.
7.
Wear anSi-approved safety goggles,
heavy-duty work gloves, and dust
mask/respirator during set up.