Home Bench Assembly Guide: Assembling the Home Bench
7
2.
Place the seat base in the upper position.
Figure 3: Raise the seat frame
3.
Attach the seat pad using two
⁵₁₆
-inch x 2
¹₂
-inch hex head bolts and two 8
mm washers. Partially tighten the fasteners using a
¹₂
-inch wrench.
Note:
To ease installation, tilt the rear bolt through the mounting hole and
thread the bolt into the seat pad. Insert the front bolt and partially tighten.
Push the seat pad forward to make room for the back pad.
Figure 4: Seat pad attachment
4.
Align the back pad with the frame. Attach the back pad using three
⁵₁₆
-inch x 2
¹₂
-inch hex head bolts and three 8 mm washers. Starting with
the top fasteners, partially tighten them using a
¹₂
-inch wrench.
Figure 5: Back pad attachment
5.
Center the seat pad and back pad, then fully tighten the fasteners using a
using a
¹₂
-inch wrench.
6.
Adjust the seat base to the lowest position.
Figure 6: Lower the seat frame
7.
Remove the protective film covering the Precor logo on the front leg of the
bench frame.
