Home Bench Assembly Guide: Before You Begin
4
Installation Requirements
Important:
Please review and follow the instructions in this guide. If you do not
assemble and use the equipment according to the following guidelines, you can void
the Precor Limited Warranty.
Follow these installation requirements when assembling the unit:
Assemble the unit near the place where you plan to use it.
Set up the unit on a solid, flat surface, so that it remains level and stable.
Open the box and assemble the components in the sequence presented in
this guide.
Insert, align, and thread all fasteners with your fingers. This helps prevent
cross-threading. Do not fully tighten fasteners until instructed to do so.
Required Tools
The following tools are required to assemble the unit:
One
¹₂
-inch wrench
Two
⁹⁄₁₆
-inch wrenches
Note:
Use box-end or open-end wrenches.
Wire cutter to cut plastic tie wraps
Hardware Kit (not to scale)
The hardware kit shipped with this equipment contains the fasteners and other
hardware components shown in the following table. Before you begin
assembly, make sure that your hardware kit is complete. If not, please contact
Precor Customer Support.
Table 1. Hardware kit contents
Fasteners
Quantity
Hex head bolt (
³₈
-inch x 2
¹₂
-inch)
2
Hex head bolt (
⁵₁₆
-inch x 2
¹₂
-inch)
5
Lock nuts (
³₈
-inch)
2
Flat washer (8 mm internal diameter)
5
Flat washer (10 mm internal diameter)
4
Note:
The
³₈
-inch bolts and the
⁵₁₆
-inch bolts are very similar, but the lock
nuts will only fit on the
³₈
-inch bolts. Test these fasteners with a lock nut
before you begin assembly.
