5.33 Elliptical Fitness Crosstrainer
Page 39
6.
Carefully, rotate the lower PCA mounting bracket away from the front cover section and
disconnect the interconnect cable from the lower PCA. Remove the lower PCA and
mounting bracket from the unit.
7.
Remove the four screws that fasten the lower PCA to the mounting bracket and remove the
lower PCA from the mounting bracket.
8.
Position the replacement lower PCA at its mounting position on the mounting bracket.
Fasten the lower PCA to the mounting bracket with the screws removed in step 7.
9.
Connect the interconnect cable to the lower and place the lower PCA and mounting bracket
in it’s mounting position. Fasten the mounting bracket to the frame with the screws removed
in step 5.
10. Connect the cables disconnected in Step 4 (See Diagram 7.4). Skip step 15
Diagram 7.5 - Lower PCA (serial code AAAB).
11. Remove the AC wiring, interconnect cable, speed sensor wiring and magnet cable from the
lower PCA.
12. Remove the single mounting screw and spacer from the lower PCA. The other three
mounting points are plastic “snap on” standoffs. Squeeze the tab on the standoff with a pair
of pliers and lift the PCA to remove the PCA from the other three mounting points.
13. Press the replacement lower PCA onto the three plastic standoffs. Place the spacer under
the forth mounting hole and fasten with the screw removed in step 12.
14. Replace the wiring removed in step 11 as shown in Diagram 7.5.
Interconnect
Cable
Speed
Sensor
AC Wiring
Magnet
Cable
Mounting
Screw
