5.17i Elliptical Fitness Crosstrainer
Page 67
Procedure 7.17 - Replacing a Stairarm
Warning:
Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm,
when the rear covers are removed.
1.
Procedure
1.
Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.
2.
Loosen and remove the two bolts that fasten the stairarm pedal onto the stairarm.
3.
Remove the stairarm pedal from the stairarm.
4.
Remove the left and/or right cover sections as described in Procedure 7.1.
5.
Remove the mounting bolt and nut that fastens the stairarm pivot block to the stairarm. (See
Diagram 7.17)
6.
Slide the stairarm off of the stairarm pivot block.
7.
Set the stairarm pedal at it’s mounting position on the replacement stairarm.
8.
Install and hand tighten the stairarm pedal mounting hardware removed in step 2. Torque
the stairarm pedal mounting bolts to 60 inch pounds.
9.
Remove and replace the wheel per procedure 7.15
10. Slide the replacement stairarm assembly onto the stairarm pivot block. Install the felt pad
and hand tighten the stairarm pivot block mounting hardware. Torque the stairarm pivot
block mounting hardware to 15 foot pounds.
11. Replace the left and/or right cover sections per Procedure 7.1.
