Precor CW-202, Инструкция по сборке

Страница: 10 / 44

CW-202 Assembly Guide
page 10
Assemble the Unit, continued
Important:
In the following two steps, insert the
bolts so that their heads face outward on both
sides. If the heads of the bolts face inward, their
threaded ends can protrude far enough to damage
the finish on barbell weight plates.
3. Attach the left-hand Weight Bar Plate to the outside
of the left-hand side of the Upright Frame using
three 3-inch carriage bolts (D)
three ½-inch flat washers (L)
three ½-inch hat washers (E)
three ½-inch locknuts (F)
Wrench tighten using a ¾-inch open-end wrench
and snap a Plastic Cap (G) over each locknut.
4. Repeat step 3 to attach the right-hand Weight Bar
Plate to the right-hand side of the Upright Frame.
6 - 3” carriage bolts
6 - washers
6 - hat washers
6 - locknuts
6 - plastic caps