C100i Adaptive Motion Trainer
Page 64
10. Remove the spacer, the inner race, two large washers and a wave washer from the
stairarm. The clearance between the stairarm shaft and the inner race is very small. It
is very easy to jam the inner race on the stairarm shaft.
11. Carefully, clean the stairarm shaft to remove any dried grease, dirt or debris.
12. Slide the wave washer and two large washers on to the stairarm shaft. Carefully, slide
the inner race all of the way onto the shaft and against the large washers. Slide the
spacer onto the stairarm shaft. The arrangement should be as shown in Diagram 7.36,
above.
13. Carefully, slide the stairarm onto the inner race on the front arm assembly.
14. Slide the remaining inner race that is in the arm into the far bearing and secure with the
snap ring.
15. Lift the stairarm and fasten it to the rear link assembly with the hardware removed in
step 1. Torque the rear links assembly hardware to 100 - 110 inch pounds.
16. Set the moveable handlebar in its mounting position on the front arm and fasten it with
the hardware removed in step 1. Slide its cover down into place.
17. Thoroughly test all AMT functions.
