C576i Self Powered Elliptical Fitness Crosstrainer
Page 64
Procedure 7.17 - Replacing a Stairarm Connector
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
1.
Remove the plastic cap from the stairarm end of the stairarm connector. Remove the bolt
that fastens the stairarm connector to the stairarm. Refer to Diagram 7.14. There are two
washers and a spacer in the stairarm connector.
2.
Remove the plastic cap from the inside lower end of the handlebar. Refer to Diagram 7.17.
Remove the bolt that fastens the handlebar to the stairarm connector. There are two
washers and a spacer in the stairarm connector.
3.
Remove the stairarm connector.
4.
Slide the spacer into the bushing in the rear of the stairarm connector and place a washer
on each side of the spacer. Set the stairarm connector at its mounting position and fasten it
with the bolt removed in step 3. Securely tighten the stairarm connector bolt. Snap the
plastic cap removed in step 3 into the stairarm connector.
5.
Slide the spacer into the bushing in the front of the stairarm connector and place a washer
on each side of the spacer. Position the handlebar and stairarm connector at their mounting
positions and hand start the mounting bolt.
6.
Securely tighten the handlebar to stairarm connector bolt. Replace the plastic cap on the
stairarm connector.
