Precor AMT 885, Инструкция по сборке

Страница: 42 / 45

To put the treadmill into an inclined position for moving:
1. Press GO on the console.
2. Increase the incline to Level 4 or more.
3. While the treadmill is running, turn the main power switch to OFF.
4. Disconnect the treadmill’s power cord.
Check the alignment of the running belt (treadmill only)
Important
Failure to align the belt may cause the belt to tear or fray, which is not covered by the
Precor Limited Warranty.
Proper alignment allows the belt to remain centered and ensures smooth operation. Realigning the belt takes a few simple adjustments. If you are unsure
about this procedure, contact Precor Customer Support.
CAUTION DO NOT adjust the running belt when someone is standing on it.
To check the alignment of the running belt:
1. Make sure that the running surface is as level as possible. If necessary, adjust the rear feet to level the treadmill.
Note Adjusting the rear feet cannot compensate for extremely uneven surfaces. If you cannot make the running surface level and stable, move the
treadmill.
2. Turn the treadmill on.
3. Stand beside the treadmill (not on it), and press GO or Quick Start on the console.
4. If necessary, enter the safety code by pressing the number keys in sequence. The running belt starts automatically after a 3-second countdown appears on
the console.
5. Press SPEED UP until the console shows a speed of 3 mph (5 kph).
6. Observe the belt from the rear of the treadmill for a few minutes. The belt should remain centered along the running bed. If it drifts off center, you need to
adjustment it.
CAUTION If you hear any rubbing or the running belt appears damaged, press the red STOP button immediately and contact
Precor Customer Support.
7. Press STOP to stop the belt and turn the treadmill off.
7