Precor AMT 885, Инструкция по сборке

Страница: 12 / 45

5
Begin assembly
Important The side arm supports are shipped with foam blocks inserted in one end.
These blocks prevent fasteners from falling into the supports. DO NOT remove the foam
blocks or push them down into the supports.
To attach the upper side arm supports:
1. Place the upper end of the right-hand support against the right-hand side arm
and insert two screws
(with washers attached) into the two holes
underneath the side arm support bracket (see Figure 1 ). Partially tighten.
Figure 1
2. Slide one washer and one sleeve over a bolt and insert it into the
screw hole on the inside of the right-hand side arm (see Figure 2).
Figure 2
3.
Attach the bolt using the nut (see Figure 3). Partially tighten.
Important Insert the bolt into the inside of the side arm and attach the nut to
the outside or the side covers will not fit.
Figure 3
4. Repeat Steps 1 through 3 to attach the left-hand side arm support.