9.17, 917si Treadmill
Page 29
8.
Lift the running belt and running bed straight up out of the treadmill frame.
9.
Set the replacement running belt and running bed in place in the treadmill frame.
10. Set the drive roller in place, be sure that drive belt is around the drive roller. Replace the two
drive roller mounting bolts. Slide the drive belt onto the drive roller pulley and tension the
drive belt per Procedure 4.4.
11. Partially tighten the running bed mounting screws removed in step 7. Center the running
bed between the treadmill frame rails and securely tighten the running bed mounting
screws.
12. Replace the take up roller and end caps.
13. Center the running belt on the running bed, be sure that the running belt is centered
between the belt trackers. Using two running belt tension gauges, tension the running belt to
0.3%
14. Snap the trim strips onto the side rails and slide them back under the end caps. The
Timmerman clips (hood mounting clips) must be fully visible with at least a 1/4” of clearance
on all sides.
15. Replace the hood.
16. Check the running belt tracking per Procedure 4.3.
17. Check treadmill operation per procedure 3.
