PrecisionTemp PT-200FT, Руководство по обслуживанию

Страница: 4 / 65

Rev 8/2014
PrecisionTemp, Inc • 11 Sunnybrook Drive • Cincinnati, Ohio, 45237 • 1-800-934-9690 •
fax 513-641-0733 4
MANUFACTURER’S LIMITED PARTS AND LABOR WARRANTY/GAS
BOOSTER HEATER
RAD Technologies, Inc, d/b/a PrecisionTemp, also called the ‘Company’ hereafter, warrants the products it manufactures to
be free of defects in both material and workmanship, under normal use and service, when installed and maintained in
accordance with PrecisionTemp written instructions, subject to the time periods, terms, and conditions stated below:
The warranty period is eighteen (18) months parts and twelve (12) months labor from the date of in-service or Factory
Authorized Start-Up. For booster heaters that are wall mounted, the Company will extend the warranty by six (6) months for
both parts (total 24 months) and labor (total 18months). The burner, heat exchanger and tank replacement are warranted for
five (5) years (parts only), which will be pro-rated after the first year (call factory for details). Defective parts will be repaired
or replaced at the manufacturer’s sole discretion.*
This warranty does not cover failure in any water components including tank, heat exchanger or pump due to freezing,
chemical attack, sediment buildup, liming, or scaling due to hard water. Labor charges will be paid by the Company based on
PrecisionTemp service labor rate schedule on work performed during regular business hours. Overtime premiums will not be
paid by PrecisionTemp. The length of the warranty on any warranty replacement item will be the lesser of ninety (90) days or
unexpired portion of the original warranty. Outside the Unites States and Canada, the Company liability is limited to the
replacement of the warranted part as specified by the time periods and conditions above.
The Company limits warranty travel time to a maximum total of two (2) hours and one hundred (100) miles. The Company
will not pay travel time or mileage that exceeds this without prior authorization. All warranty service must be completed by
the Company or its authorized agencies. The Company does not authorize any other person or company to perform warranty
service on the Product.
IN ALL EVENTS, NO WARRANTY OF ANY KIND, EXPRESSED OR IMPLIED, SHALL EXTEND BEYOND THE
RESPECTIVE TIME PERIODS OR TERMS DESCRIBED ABOVE. IN NO EVENT WILL PRECISIONTEMP BE
LIABLE FOR INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES SUCH AS LOSS OF USE OR INJURY TO
OTHER PROPERTY, LABOR COSTS, OR LOST PROFITS RESULTING FROM USE OR INABILITY TO USE
PRODUCT.
IN ORDER TO ACTIVATE THE TERMS OF THIS WARRANTY, THE PURCHASER MUST CONTACT
PRECISIONTEMP AND PERFORM A FACTORY AUTHORIZED START-UP.
*Accessory components supplied by PrecisionTemp, carry a one-year parts only warranty. Accessory components include, but
are not limited to: temperature gauge, expansion tank, ball valve, drain valve, pressure reducing valve, and relief valve.
Labor to replace these components is not covered by this warranty.
LIMITED WARRANTY PROVISIONS
This warranty is intended to provide you with protection against abnormal failure due to faulty materials or workmanship. It
does not cover adjustment or replacements due to normal wear. This warranty shall not cover:
1.
The cost of labor for stopping leaks that may be corrected by tightening.
2.
Damage resulting from untreated hard water conditions resulting in liming or scaling, clogging of valves preventing
proper operation, objects such as dirt, sand, chemical buildup or debris, or broken parts caused by solder or other debris
passing through this unit.
3.
Transportation, installation or removal costs are not covered by this warranty. This warranty does not cover any
failures or operating problems due to abuse, accident, alteration of equipment, improper installation, negligence, application
of improper voltage, or recalibration of thermostats or limit switches.
4.
Damage caused by over-voltage or use with utility service other than designated on the machine’s rating plate or
improper connection to utility service. Failure to comply with local building codes, inadequate wiring or plumbing.
5.
Damage caused by excessive water pressure.
6.
Regular maintenance is owner’s responsibility.
7.
Any additional time required to gain access to service the equipment. Additional charges will be billed to the
customer.
8.
Incidental, special, or consequential damages such as loss of use or injury to other property, labor cost, or lost
profits resulting from use or inability to use product.
This warranty is void if defect is due to damage from shipment handling, fire, water, accident, abuse, misuse, acts of God,
attempted repairs or improper installation by unauthorized persons, if serial numbers or identifying marks have been
removed or altered, or if equipment is used for purposes other than that for which it is intended. 7/2008