Precision matthews PM-940V-PDF, Руководство пользователя

Страница: 8 / 23

TO CHANGE TOOLS
(1)
Removing Face Mill or Drill Chuck Arbor
Loosen the arbor bolt at the top of the spindle shaft approximately 2 turns
with a wrench. Rpa the top of the arbor bolt with a mallet.
After taper has been broken loose, holding chuck arbor on hand and turn
detach the arbor bolt with the other hand.
(2)To install Face Mill or Cutter Arbor
Insert cutter and cutter arbor bolt detach securely, but do not
over-tighten.
(3)Removing Taper Drills
(a) Turn down the arbor bolt and insert the taper drill into the spindle
shaft.
(b) Turn the rapid down handle rod down until the oblong hole in the rack
sleeve appears. Line up this hole with the hole in the spindle. Insert
key punch key through holes and strike lightly lightly with a mallet.
This will force the taper drill out.