6
Copyright © 2020 Quality Machine Tools, LLC
PM-835S v3 2020-10
Figure 2-4
Hoisting by slings
Move the ram in or out as necessary. Protect the ram ways with
padding.
Figure 2-3
Hoisting by eyebolt
The head is shown here swiveled 90º counter-clockwise.
Power hook-up
•
Before running the machine, be sure that the spindle and
quill are
properly lubricated
, see Section 4.
•
Remove any clamps or other temporary items that might
interfere with normal operation of the machine.
•
Check the available power supply for compatibility with
the motor.
•
Check for correct spindle rotation. With the motor switch
set to FWD and the SPEED RANGE selector set to HI,
the spindle should rotate clockwise when viewed from the
top of the machine (single-phase motors are pre-wired
that way). Three-phase motors can be reversed by phase
swapping.
•
Some users prefer the FWD rotation to be clockwise when
the back gear selector is set to LO. This calls for re-wiring
if the motor is single-phase.
Tighten all bolts
and lock levers
before lifting
Tighten all bolts
and lock levers
before lifting
Eyebolt
thread
M20 x 2.5
