WARNING
Do not connect or disconnect under load.
Ensure driver has not been powered for a minimum of 1 minute before reconnecting the
LED module after disconnecting. Do not hot plug. Failure to follow this instruction will lead to
serious damage of the LED module and driver and will not be covered by warranty.
NOTE
LED module is not site serviceable.
Tampering will cause damage and will not
be covered by warranty.
NOTE
Maintain correct polarity when wiring. Incorrect wiring will cause serious damage and
will not be covered by warranty. Must be installed according to SELV regulations.
Wire specification: 22 AWG, ø0.65mm diameter double insulated teflon wire.
Red - Positive
Black - Negative
Driver
Domino 4 Recessed
Domino 2 Recessed
ø44
66 mm
2 19/32”
ø44
22
7/8”
1. Installing the luminaire
WARNING
switch off power to mains
before installation.
Cut ceiling hole using the stencils in
diagram 1.1.
Note:
Due to small luminaire size
drivers must be located remotely when
using the Domino 1; cut out is too small
for dimmable drivers to pass through.
Pull driver side connector through
hole and connect to the luminaire side
connector. See electrical instructions for
wiring schematic. Compatible drivers
listed in front page table.
Using installation springs, install fixture
into the ceiling.
Please note the Domino
Recessed 1 requires remote
driver location due to small
cutout size.
Domino 1 Recessed
ø44
1 3/4”
REMOTE DRIVER ONLY
PRINT TO SCALE
1.1
1.2
