P
RO
V
U
™ PD6088/PD6089 Modbus
®
Scanner
Instruction Manual
13
Installation Overview
We recommend the following sequence for getting the
scanner into service:
1.
DO NOT
apply AC or DC power to the scanner.
2. Connect the scanner to the PC with the USB
cable provided.
DO NOT
use a different USB
cable.
3. If ScanView (SV) is already installed in your
computer, then the program will launch
automatically in most systems. If the program
does not start automatically, double-click on the
SV icon.
4. If SV is not installed, follow the instructions
provided below.
5. Use SV to configure the scanner for your
application.
6. Disconnect the USB cable from the scanner.
7. Apply power and signal and check operation of
the scanner.
8. Install the scanner and put into service.
9. Make any programming adjustments using the
front panel buttons.
ScanView Software
The easiest and quickest way to program your P
RO
V
U
scanner is to use the FREE ScanView programming
software. This software is loaded into the scanner and
connects and installs directly to your PC with the USB
cable provided.
DO NOT
use a different USB cable.
We recommend that the first thing you do after taking
the scanner out of the box is connect the P
RO
V
U
to
your PC with the provided USB cable.
DO NOT
apply
AC or DC power to the scanner while your PC is
connected to the scanner as it will disrupt the USB
connection. It is not necessary to apply an input
signal.
ScanView programming software is intuitive, and
most customers can get their scanner programmed as
they like without even looking in the manual.
For more information on ScanView visit
www.predig.com/ScanView
