PDW30 Point-to-Point Wireless Bridge Instruction Manual
8
Connections
To access the connectors, remove the enclosure cover and unscrew the two captive stainless steel
screws. Remove the electronics assembly from the enclosure. Signal connections are made to removable
terminal blocks on the back of the electronics assembly. Grounding connections are made to the two
ground screws provided on the base
– one internal and one external.
Static electricity can damage sensitive components.
Observe safe handling precautions for static-sensitive com-
ponents.
Use proper grounding procedures/codes.
Warning!
Observe all safety regulations. Electrical wiring should be per-
formed in accordance with all agency requirements and appli-
cable national, state, and local codes to prevent damage to
the meter and ensure personnel safety.
Figure 1 below shows the locations of screw terminal blocks on the rear of the wireless unit assembly.
Figure 1. PDW30 Device Assembly, Rear View
Wireless
Module
