PDW30 Point-to-Point Wireless Bridge Instruction Manual
19
Password Setup
Both the primary and secondary wireless units may be protected with a four digit numeric password in or-
der to prevent unauthorized tampering. When a password has been set, you will be prompted to enter
that password in order to access the device menu.
To disable password protection, simply enter
0000
as the password.
Note: See
Entering Numeric Values
on page 16 for instructions on how to enter numbers
Making Changes to a Password Protected Meter
Once a password has been set on the device, you will be required to enter that password before being
allowed to access the device menu.
Note: Setting a password will require you to enter the password to access the device settings via the PC
software as well.
Did you forget the password?
Connect the device into a PC running
PDW Manager
and
select
reset all device parameters to factory defaults
.
Restore Defaults
If a mistake has been made while programming the primary or secondary device, and it is unclear where
the error occurred, the best option may be to perform a factory reset of the device and begin again.
SETUP
PASSWORD
NOW: 0000
PASSWORD (0=OFF)
SETUP MENU
BACK TO
SET: 0123
PASSWORD (0=OFF)
increments selected digit.
selects next digit to the right.
0000
disables the password.
LINK OK
PRI RSSI 10 RT
0000
ENTER PASSWORD
Run Mode
ACCESS GRANTED
increments selected digit.
selects next digit to the right.
TRY AGAIN
ENTER PASSWORD
1 Sec
If
In
co
rre
ct
DEFAULTS
RESTORE
NO
LOAD DEFAULTS?
YES
LOAD DEFAULTS?
Unit will load default
settings and reboot.
