Precision CAM Cowcam, Руководство пользователя

Страница: 34 / 48

29
USING YOUR SYSTEM: THE DVR
Viewing recorded footage:
•
Right click on the screen and click “ search ” from the drop down menu. You may
be asked to log in at this point.
•
You will see a calendar on the right side of the screen, use this to select the day
from which you wish to view footage.
•
Once you select the date you will see the video clips that are available to view
on the timeline at the bottom of the screen. To watch just click on the timeline.
Saving recorded footage:
•
Plug a USB stick into the DVR.
•
Go to the same menu you would use to view the footage and select where you
would like the saved footage to start on the time line.
•
Click the video clip icon at bottom right corner of the screen.
•
Then click the save icon at the bottom right corner.
•
Select the video clips you want to save, select the device you want to save them
to and click backup.
•
The video will then take a few minutes to record to the USB stick.
Viewing the saved footage on a pc:
•
Plug the USB stick into your pc and open it up.
•
Run the application on the USB stick called “ play ”.
•
Click the small arrow icon on the far left side of the tool bar and browse
through your files until you get to the USB stick.
•
Click the .DAV files that are on the USB stick and they will start playing.
Viewing the DVR on your smart phone:
The first time you view your camera from your smartphone or tablet you will have to
configure the DVR as well as your phone. After the first time you set everything up,
viewing the camera will be fairly simple.
Part 1 — Setting up P2P on the DVR:
This part of the setup should already be done when you receive the DVR, but just In
case you have to reset your DVR or it has not been configured already, follow these
steps first. Otherwise skip forward to the Smartphone configuration section.
•
Right click on the screen of the DVR and select main menu from the drop down
menu. At this point in time you may need to log in.
•
Click network under the setting section of the menu, go to the TCP/IP section of
the menu (if not there already), and change the mode to DHCP. Click apply.
•
Now go to the P2P section of the menu and click enable (so the box has a check
mark) then click save.