Pratica EC3, Инструкция по установке и эксплуатации

Страница: 4 / 28

INSTALLATION
Introduction
Observe the following instructions to install your EC3 oven properly and take advantage of all its
features.
Not observing the installation instructions below may void its warranty and result in harmful
consequences.
The instructions below provide for the minimum requirements for correct oven operation.
Ask your local authorities for other restrictions that may apply to your specific location.
The EC3 oven installation requires:
Ÿ
Flat and leveled surface
Ÿ
Electricity supply
Ÿ
Cold water supply
Ÿ
Connection to the water drain system
WARNING: All maintenance requiring the removal of any oven cover must be made by certified
technicians.
Location
The EC3 must be located on a flat and leveled surface, in a place protected from water steam, cooking
oil spills, heat, and other gases or liquids, for they can damage the digital electronic control. A
clearance of 1/2' (15cm), should be observed from any walls or vertical surfaces to allow the oven
ventilation.
Electricity
WARNING: Not grounding the oven properly may cause human damage and automatically voids the
oven warranty. Consult with a certified technician to prepare for oven installation.
02
ELETRICAL SPECIFICATIONS
Make sure that the eletrical diagram of the building is according with the
technical specications
Grounding is required. In case of damage to the equipment or third parties,
the consumer will be responsible if he did not comply with the technical setup
recommendations.
Use an exclusive circuit breaker for the oven, positioned at a maximum
distance of 60" and to the right of the equipment.
It is recommended to set a connector for the power cable to facilitate the
product’s displacement.
Model
EC3
Voltage
(V)
208/240
Phases
Frequency
(Hz)
Power
(kW)
Circuit
(A)
Consumption
(kWh)
Cable
(AWG)
Socket
(NEMA)
1
60/50Hz 6,3 4,4
3x10 6-30 30A