Pramac Pmi3000, Руководство оператора, Страница: 19 / 153

16
user has right tools or mechanical expert. If do the self inspection, user must
contact with local agent in advance.
7.2 Engine oil change
When the engine is warm, engine will be empty of oil easier and faster, see figure 12.
Figure 12 Change engine oil
1. Screw off and take out dipstick.
2. Disassemble oil drain bolt (or open oil drain valve, if there is ), exhaust scrap oil, then
tighten (or close oil drain valve, if there is).
3. Fuel recommended oil and check the oil level.
4. Tighten dipstick.
Oil capacity
：
0.52L
7.3 Air filter maintenance
Dirty air filter will block air into the carburetor. In order to prevent the carburetor breakdown,
please maintain the air filter regularly. If used in the dirty areas, need more frequent
maintenance.
1. Screw off the screw on the bottom of the air filter and disassemble the air filter cover.
2. Take out the filter element, use compressed air to blow or knock the dust out from filter
element inside, if seriously dirty, change it.
3. Install the filter element back to the Air filter cartridge, replace the air filter cover and
tighten the screws.

Never run the generator without air filter, otherwise engine will wear quickly.

Do not use gasoline or low flash point solvents to clean the generators, because
they are flammable and explosive under certain conditions

In order to meet environmental requirements, we suggest that you put the scrap oil
into a sealed container and send it to local service station or recycling center. Don’t pour
it on the ground or in the trash.