GSW
Connections to panel type (E):
In some generator models the electric control part
could be installed separately from the power part. In
this case, there will be 2 different electric panels: the
“control board” and the “power board”, which will
normally be positioned on the two opposite sides of
the base near the power alternator.
Control board:
Closed power board:
•
Remove the two fixing screws (
1
) using the
appropriate spanner and open the protection panel
(
2
).
•
Pass the cables through the bottom side of the
panel through the specific opening positioned
underneath the electric panel (
3
).
•
Connect the cables to the specific terminals (
4
)
following the indications on the wiring diagrams
supplied with the generator.
•
Close the protection panel (
2
) and tighten the two
fixing screws (
1
) with the specific spanner.
Open power board:
4.INSTALLATION
79
