Praher Plastics AQUASTAReasy II, Руководство пользователя, Страница: 41 / 44

www.praher-plastics.com 21
a) Power loss
Cause: The power supply has been interrupted
Action: When the Aquastar is at an unsafe position it approaches filter if the main
supply is back.
Signal: 1s
Reset: Connect power.
Possible reasons: Power loss. Cable break
b) Current error
Cause: The permitted motor current has been exceeded
Action: The motor stops. After two seconds the Aquastar retries to reach position
Signal: 3s
Reset: No need to reset. If current is below current-limit in the next attempt,
normal operation goes on
Possible reasons: Aquastar is not enough fixed to the valve
c) Current error state
Cause: The permitted motor current has been exceeded three times in this
position cycle
Action: Aquastar is set to errorstate. No possible actions until Aquastar is reset
Signal: 4s
Reset: Press “ON” and “OFF” Button simultaneously for at least 5s
Possible reasons: Aquastar I not enough fixed to the valve. Motor is broken. Valve is broken.
Pump has not been turned off. Water column of 3 meter exceeded.
d) One Hall error state
Cause: Chosen position has not been reached within 3 minutes or 3 rounds.
Action: Aquastar is set to errorstate. No possible actions until Aquastar is reset
Signal: 5s
Reset: Press “ON” and “OFF” Button simultaneously for at least 5s
Possible reasons: Defective electronics
e) Hall error state
Cause: Motor has been turned on but no position change for 30 seconds
Action: Aquastar is set to errorstate. No possible actions until Aquastar is reset
Signal: 6s
Reset: Press “ON” and “OFF” Button simultaneously for at least 5s
Possible reasons: Defective electronics. Insufficient power supply. Motor is broken. End pos.
switch is not connected. Motor is not connected.