PRACTIXX PX-RRM-600WI, Руководство по эксплуатации и технике безопасности

Страница: 42 / 68

34 | GB
Information about collection points for old devices
can be found at your municipal authority, the local
disposal provider, an authorised location for the dis-
posal of old electrical and electronic devices or your
waste collection service.
Do not throw primary batteries or rechargeable
batteries away with household waste!
As a consumer, you are legally obliged to hand
in all batteries and rechargeable batteries, re-
gardless of whether they contain harmful sub-
stances* or not, to a collection point in your munici-
pality/district or to a retailer so that they can be
disposed of in an environmentally friendly manner.
*marked with: Cd = cadmium, Hg = mercury, Pb =
lead
15. Troubleshooting / fault codes
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
15.1 Fault table
Fault Possible cause Remedy
Mower does not start
Mower or charging station not con-
nected to the mains
• Connect the power supply unit to a suitable
power source
• Call a specialist if necessary
LED light on charging station
does not light up
LED light on charging station
flashes red
Boundary wire is not connected or
cut/broken.
• Connect/repair boundary wire
Mower does not mow properly Blades are worn • Replace blades
Mower starts at unusual/
wrong times
Date/time is incorrectly set • Set the correct date and time
Mower gets stuck Unsuitable terrain/obstacle
• Adapt the terrain/obstacle to the requirements
of the robot mower
• Adjust the laying of the boundary wire accord-
ingly
15.2 Fault codes
Error code Meaning Remedy
---- Rain sensor delay • -
E1
Mower outside the working
area
• Check that the mower is in the working area.
• Ensure that the charging station is properly connected to the charger
and the charging unit is connected to a suitable power supply. If proper-
ly connected, the boundary wires are incorrectly attached and must be
transposed.