INSTALLING THE PROJECTOR
The unit was designed to make installation easy: it can be fitted on a floor, wall or ceiling as required
and will operate in any working position, as the head can be rotated through 90°.
Always ensure that the projector is firmly anchored to avoid vibration and slipping whilst functioning.
Always ensure that the structure to which you are attaching the projector is secure and is able to
support a weight of 17.6Kg for each Design 150. For safety the projector should have a secondary
fixing with a safety chain through the 2 secondary safety yokes on the both sides of the unit.
Note: For installing the barndoors, first install the 4 copper screws and sealing rubber washers in the
unit head, and then place the barndoors on the 4 copper screws and fasten them with 4 screws and
flat washes.
FITTING THE LAMP
Loosen the 2 M6 screws and then open the head cover as shown in the figure above.
Appear the lamp holder by letting the colour filters and blades aside from the center.
Plug the lamp into the lamp holder.
Note:
To avoid premature lamp failure, do not touch the lamp
glass with your fingers. If you touch the lamp during installation, clean it carefully with rubbing alcohol
and a clean, lint-free cloth before operation.
Close the cover and then tighen the 2 M6 screws.
NOTE:
The HSD series are high pressure lamps with external igniters (
). Care should always be
taken when handling these lamps. Always read the manufacturers "Instructions for use" enclosed with
the lamp.
Design 150 manual.doc
4/12
