PR Lighting CHAMELEON PR-2012H, Руководство пользователя

Страница: 5 / 12

Chameleon manual.doc 5/12
The projector can be controlled by sound, auto-programmes or a controller, and can be operated in
Stand-Alone mode, Master/Slave synchro mode or Controller mode.
When the power is on, the projector will reset automatically for operation.
TO SET THE ADDRESS OF DIP SWITCHES
The DIP switch of the CHAMELEON has 10 switches with the number from 1 to 10, which may be set
on the “ON” or “OFF” position. You should set the DIP switch correctly to operate the projector. (See
“Stand-alone mode”, “Controller mode” and “Master/Slave synchro mode” for detail)
XLR CONNECTORS
Connection between controller and projector and between one projector and another must be made
with 2 core screened cable, with each core having at least a 0.5mm diameter. Connection to and from
the projector is via cannon 3 pin XLR plugs and sockets which are included with the projector. The
XLR's are connected as shown in the figure above.
Note, care should be taken to ensure that none of the connections touch the body of the plug or each
other. The body of the plug is not connected in any way. The CHAMELEON accepts digital control
signals in standard DMX512 (1990) format.
5-PIN AND 3-PIN CONVERSION
CHAMELEON uses 3-pin XLR plug / socket. If your controller uses 5-pin XLR plug / socket, you
should convert 5-pin plug / socket into 3-pin socket / plug as shown below.
DMX TERMINATOR
In the Controller mode or Master/Slave mode, the DMX output has to be connected with a DMX
terminator at the last fixture in the chain. This prevents electrical noise from disturbing and corrupting
the DMX control signals.
The DMX terminator is simply an XLR connector with a 120
Ω
(ohm) resistor connected across pins 2
and 3, which is then plugged into the output socket on the last projector in the chain. The connections
are illustrated on the right.
The terminator is added a 120
Ω
resistor between pin-2 and pin-3 in a Canon plug, which can avoid the
reflection during the DMX-512 signal transmission.
DMX TERMINATOR
CONNECTION
Connect a 120
Ω
(OHM) resistor across
pins 2 and 3 in an XLR plug and insert
into the DMX OUT socket on the last
unit in the chain.
OPERATION
XLR CONNECTORS AND TERMINATOR