PR Lighting CHAMELEON PR-2012H, Руководство пользователя

Страница: 4 / 12

Chameleon manual.doc 4/12
This unit has been designed to be hung. Mount the bracket provided on the body of the projector.
There are 2 M8 knobs provided to tighten the body and the bracket. When you want to adjust the
angle of the body of the projector, you only loosen the two M8 knobs carefully and then adjust the
angle of the body. After finishing that, it is recommended that you don’
t forget to retighten the two M8
knobs. Always ensure that the projector is firmly positioned to avoid vibration and slipping and always
ensure that the structure to which you are attaching the projector is secure and is able to support a
weight of 6.9kg for each CHAMELEON.
For safety the unit should have a secondary fixing with a safety cable through the two handles on the
back of the unit, and the safety cable should afford 10 times of the unit’
s weight.
Remove the lamp access hatch
by loosening the 2 M4 screws
Insert an ELC-7/X 24V/250W
lamp in the lamp-holder.
Plug the lamp into the lamp-
bracket until the lamp is fully
seated, and let the two spring
press the lamp stably.
Install the lamp access hatch
again.
Retighten the 2 M4 screws.
Use the plug provided to connect the mains
power to the projector paying attention to the
voltage and frequency marked on the panel of
the projector. It is recommended that each
projector is supplied separately so that they
may be individually switched on and off. It is
recommended that
the green/yellow power-
cord must be earthed correctly .
FITTING THE LAMP
INSTALLING THE PROJECTOR
POWER SUPPLY - MAINS