PR Lighting AQUA LED 600 SPOT, Руководство пользователя, Страница: 8 / 30

8/30
Lock the tilt and unfasten 4 inner hexagon screws in the small cover of the head. Open the cover and you’ll see the structures as the
figures above.
For the replacement of color filters, use the fingers to remove the filters and place new ones.
For the rotating gobos: remove the rotator by hand; remove the gobo after the tightening spring for the gobo is taken out. Place a new
gobo in the rotator and put back the spring. And ensure the spring is into the narrow end of the rotator, i.e., inner ring of the rotator. At
last, use a proper tool to pull the tightening clip and put the rotator back to the wheel with the help of the other hand.
Note: Do not touch the color filters ,glass gobos with bare hand. There must be soft and clean paper or cloth between the hand and the
glass gobo. Tighten the 6 fast fit screws after the cover is put back. Unlock the Tilt.
DANGER!
Before replacement of gobos, the projector must be off the power.
5. SETUP AND CONFIGURATION
●
FRONT PANEL OPERATION
DMX
W-DMX
ETHERNET
FUNC
UP
DOWN
ENTER
Projector configuration can be set conveniently via push buttons and touch screen.
Launch the projector and press button ENTER for more than 5 seconds to unlock the panel, the LCD will show the function menu of
the projector, each main menu has its submenus and each submenu has a specific function. For details, please see the
“OPERATION MENU” section.
Press button UP or DOWN if you want to browse through the various Setup Options.
Press button ENTER to save your settings or enter the submenu.
Press button UP or DOWN to change values(plus or minus)
Press button FUNC, it will return to the upper menu. If button FUNC not pressed, the default will show display status automatically.
●
DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The projector has 3 DMX modes. There are short, standard and extended modes. For example standard mode has
31 c hannels, so set the No. 1 projector’s address 001, No. 2 projector’s address 032, No. 3 projector’s address 063, No. 4 projector’s
address094, and so on.
Launch the projector. Press button ENTER more than 2seconds to unlock panel.
Press button ENTER to display DMX address;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm; after powered on next time, the default will be last value saved
Press button FUNC, it will return to the upper menu
.
●
DMX WIRELESS CONTROL (If the projector has the function)
The projector has wireless control function with wireless receiver module and antenna for remote control.