11
User Manual
neuro 200
The indicator is needs to be appropriately configured in terms of input and other features like digital filter etc. The
PAGE-12
presents Input configuration parameters that are listed below in Table 6.1 .
PAGE-12 : INPUT CONFIGURATION PARAMETERS
Table 6.1
Parameter Description
Settings
(Default Value)
Refer Table 6.3
(Default : Type K)
Refer Table 6.3
(Default : 1)
Refer Table 6.2
(Default : ºC)
(Not Available for Thermocouple Inputs)
Set the process value indication resolution (decimal point). All the
resolution based parameters (hysteresis, alarm setpoints etc.)
then follow this resolution setting.
RESOLUTION
Select Temperature units in ºC or ºF for Thermocouple or Pt100
sensor.
For DC Linear input (mA/mV/V), Select appropriate Units from the
list in Table 6.2. Note however that the selected Units are for the
purpose of Lower Readout indication only.
UNITS
Section 6
SIGNAL RANGE LOW
SIGNAL RANGE HIGH
This parameter is available only if the selected input type is DC
Voltage / Current and defines the transmitter output signal value
corresponding to Range High process value.
Input Type
Settings
Default
0 to 20 mA
4 to 20 mA
0 to 80 mV
0 to 1.25 V
0 to 5 V
0 to 10 V
1 to 5 V
Signal Low to 20.00
20.00
20.00
80.00
1.250
5.000
10.00
5.000
Signal Low to 20.00
Signal Low to 80.00
Reserved
80.00
Signal Low to 80.00
Signal Low to 1.250
Signal Low to 5.000
Signal Low to 10.00
Signal Low to 5.000
Input Type
Settings
Default
0 to 20 mA
0.00 to Signal High
0.00
4 to 20 mA
0 to 80 mV
0 to 1.25 V
0 to 5 V
0 to 10 V
1 to 5 V
4.00 to Signal High
0.00 to Signal High
0.000 to Signal High
0.000 to Signal High
0.00 to Signal High
1.000 to Signal High
4.00
0.00
Reserved
0.0 to Signal High
0.0
0.000
0.000
0.00
1.000
This parameter is available only if the selected input type is DC
Voltage / Current and defines the transmitter output signal value
corresponding to Range Low process value.
Select Input type in accordance with the type of Thermocouple or
RTD sensor or transducer output connected for process value
measurement. Ensure proper hardware jumper settings, if
required.
INPUT TYPE
