6
OPERATION OF SELF-CONTAINED CARPET CLEANER
1) Plug main power cable into outlet.
WARNING: This machine must be
properly
grounded.
2) Press the Vacuum switch to the ON
position. Then press the pump switch ON
and the brush switch to the ON position.
3) Lower carpet brush. Push brush lowering
pedal forward to lower brush. Push down
and back to raise bush.
4) Press and hold the solution switch to
apply the cleaning solution. Pull the
machine backwards at the same time to
clean the carpet. Stop the solution spray
about 12” (30 cm) before the end so all
of the solution is vacuumed up. Slightly
overlap the next cleaning pass to prevent
streaking. A two (2) wet pass maximum
is recommended to avoid overwetting.
After a few passes, check the waste tank
to see that no foam is present. Add extra
defoamer if necessary.
5) Make sure to empty the recovery (top) tank
when it is approximately 3/4 full. Do not
refill the solution tank without emptying all
the contents of the recovery tank first.
GENERAL INSTRUCTIONS
WHEN CLEANING IS FINISHED:
1) Connect the drain solution hose (gray
hose with brass connector) to the
solution fitting at the front of the machine
and place the other end at drain. Turn
on the PUMP switch. This will pump the
remaining solution into the waste tank for
easy drainage.
2) To disconnect the solution hose, push in
on the ring of the solution filling. Switch
off the machine, remove power plug from
the socket, and empty the waste tank.
Leave waste tank open when storing.
3) Leave brush raised for storage.
STORAGE
