The area to be scrubbed:
Debris and grit must be swept up
before starting the scrubbing operation to avoid vacuum line
blockage and to permit the detergent to perform efficiently.
Prior to startup and operation:
Caution:
A)
Loose objects
on the floor can become dangerous projectiles if struck by the
high speed pad. Remove them before operating machine.
B)
Keep machine moving to prevent damage to finish or floor.
C)
These machines are designed for level floor operations only.
DO NOT OPERATE ON RAMPS OR INCLINES
unless
adequate personnel are available for assistance.
Starting up and operation:
Disconnect the batteries from the
battery charger and connect to the machine.
Then:
• Turn master switch
M6
to position 1 and press
switches
M7
and
M8.
• Lower the brush by pressing pedal
M9.
• Lower the squeegee by pressing pedal
M3.
• Set the detergent solution supply to minimum by
adjusting knob
M12.
• Finally, adjust the correct supply of the detergent
as a function of the amount of dirt and speed of
advance by means of lever
M12
Brush/pad install:
The PAS20BA features hands free brush
installation.
To install a brush on the PAS20BA, simply leave the brush on
the floor under the front of the machine.
• Turn the switch
M7
and the handle
M10
.
• Release the pedal
M9
.
If the brush does not hook up immediately, make small side
movements with the auto scrubber until the brush is installed.
To replace a worn brush or pad:
• With the machine on and the brush in the upper
position, press the pedal
M9
to lift the brush.
• Release the handle
M10
and the brush will release
and drop to the floor.
The machine is supplied with a pad driver. Brushes in carbide
grit, poly and steel are available on request, together with floor
pads recommended for use with the pad driver.
Black
for
stripping,
green
for deep scrub,
blue
for cleansing and red for
light scrub.
- 4 -
https://harrissupplyind.com - To Order Parts Call 608-268-8080
