17 - ENG
STOrAGE
ENGINE
Consult the Engine Owners Manual for
manufacturer’s recommendations for
storage.
pUMp (fIG. 17)
The manufacturer recommends using a
pump protector/winterizer when storing
the unit for more than 30 days and/
or when freezing temperatures are
expected. Pump protector/winterizer
is usually available at the store where
the pressure washer was purchased.
If a pump protector/winterizer is not
available, RV antifreeze needs to be
run through the pump as outlined in the
steps below.
NOTE:
Using a pump protector/
winterizer or RV antifreeze is to provide
proper lubrication to the internal seals
of the pump regardless of temperature
or environment.
1. Obtain a funnel, 6 ounces (170 mL)
of RV Antifreeze, and a 16" to
36" (40-91 cm) section of garden
hose with a male hose connector
attached to one end.
17
NOTICE:
Risk of Property Damage.
Use only RV Antifreeze. Any other
antifreeze is corrosive and can damage
the pump.
2. Disconnect the spark plug wire.
3. Connect the length of garden hose
to the water inlet of the pump.
4. Add RV Antifreeze to hose as
shown.
5. Pull starter rope slowly several
times until antifreeze comes out of
the high pressure hose connection
of the pump.
6. Remove garden hose from water
inlet of pump.
7. Reconnect spark plug wire.
pRESSURE WAShER
1. Drain all water from high pressure
hose, coil it, and store it in
cradle of the pressure washer
handle.
3. Drain all water from the spray gun
and wand by holding spray gun
in a vertical position with nozzle
end pointing down and squeezing
trigger. Store in gun holder.
3. Store detergent siphon hose, if so
equipped, so it is protected from
damage.
AccESSOrIES
DANGER: Risk of fluid injection.
When using replacement lances or
guns with this pressure washer, DO
NOT use a lance and/or lance/gun
combination that is shorter in length
than what was provided with this
pressure washer as measured from
the nozzle end of the lance to the
gun trigger.
NOTICE: The use of any other
accessory not recommended for use
with this tool could be hazardous.
Use only accessories rated equal
to or greater than the rating of the
pressure washer.
SpEcIFIcATIONS
Model
pW2623C
PSI Max*
2600 psi
GPM Max*
2.3 gpm
High Pressure Hose
25 ft. (7.6 m)
Presure of Inlet Water
20–100 psi
Inlet Water
cold tap
Soap Consumption Rate 10% max
* Water flow and maximum pressure
ratings determined in accordance
with PWMA standard PW101.
