15 - ENG
C
11
I
6. Connect water source (N) to pump
inlet (J).
NOTE:
Water source must
provide a minimum of 5 gallons per
minute at 20 psi.
N
12
J
WARNING: To reduce the
possibility of contamination always
protect against backflow when
connected to a potable water system.
7. If applying a chemical or cleaning
solution, see
how To Apply
Chemicals/Cleaning Solvents
instructions in this section.
8. Turn water source on.
NOTICE:
Risk of property damage.
Failure to do so could cause damage
to the pump.
9. Remove all air from the pump and
high pressure hose by depressing
trigger until a steady stream of
water is present.
10. Start engine. See Engine Owners
Manual for correct procedure.
WARNING: Risk of unsafe
operation. If engine does not start
after two pulls, squeeze trigger of
gun to relieve pump pressure. pull
starter cord slowly until resistance
is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arm
injury.
11. Depress trigger on gun to start
water flow.
WARNING: Risk of unsafe
operation. Stand on a stable surface
and grip gun/spray wand firmly with
both hands. Expect the gun to kick
when triggered.
12. Release trigger to stop water flow.
WARNING:
13
O
Risk of injury
from
spray.
Always engage
the trigger lock
(O) when gun is
not in use. failure
to do so could
cause accidental spraying.
13. Adjust nozzle spray for the task
being performed. See
how To Use
spray Wand
instructions in this
section.
ShUTTING DOWN
1. After each use, if you have applied
chemicals, place detergent siphon
hose into container of clean water
and draw clean water through
chemical injection system to rinse
system thoroughly.
NOTICE:
Risk of property damage.
Failure to do so could cause damage
to the pump.
2. Turn engine off. See Engine
Owner’s Manual.
NOTICE:
Risk of property damage.
NEVER turn the water off with the
engine running.
3. Turn water source off.
4. Pull trigger on spray gun to relieve
any water pressure in hose or spray
gun.
5. See
Storage
section in this manual
for proper storage procedures.
mAINTENANcE
WARNING: Risk of burn hazard.
When performing maintenance, you
may be exposed to hot surfaces,
water pressure or moving parts that
can cause serious injury or death.
