Powerware 9125 PowerPass, Руководство пользователя

Страница: 37 / 56

31
Powerware
®
9125 Two-in-One (5000/6000 VA) PDM User’s Guide
S
Rev B www.powerware.com
Chapter 3 Configuration
This section describes how to reconfigure options using the
Configuration mode, including output voltage and site wiring fault.
Configuration Mode
When the UPS is in Configuration mode, the bar graph indicators
represent the configuration options. The control buttons (On button
and button) are used to modify the UPS configuration. Figure 19
shows the LEDs and Table 4 explains the corresponding options.
NOTE
The UPS can be configured while in Battery mode.
C A U T I O N
DO NOT press the Off button while the UPS is in Configuration mode;
pressing the Off button removes all power to your equipment immediately
and the UPS enters Standby mode.
1.
Press the On button and the button simultaneously for
three seconds. The UPS switches to Configuration mode.
The bar graph indicators flash briefly and then display the
enabled options.
2.
Press the On button to scroll through the options. Each time
you press the button, the UPS beeps. The LED for the selected
option indicates the current setting; flashing represents disabled
options (see Figure 19 and Table 4).
If you press the On button and nothing happens, the UPS is
still in Operation mode. Repeat Step 1 to enter Configuration
mode, and then perform Step 2.