Installation
7
Powerware
®
5119 Rack Mount User’s Guide
:
www.powerware.com
4.
Plug the equipment to be protected into the UPS output
receptacles.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
5.
Start the UPS by pressing the On button as shown in Figure 5.
The Power On indicator illuminates indicating that power is
available from the rear receptacles.
The installation is complete. To learn how to operate the UPS,
see “Operation” on page 13. To change the factory-set defaults,
see “Configuration” on page 17.
NOTE
The UPS charges to 90% in approximately 4 hours. However, it is
recommended that the UPS charge for 24 hours after installation or long storage.
2
&
3
This is a typical setup;
your setup may vary.
NOTE
4
5
1
Connect equipment to UPS
Load
Load
Power On Indicator
Press the On button
(on the front panel)
Connect UPS to power
UPS
Output Receptacles
Connect communication
cable from computer
to UPS (optional)
IEC Male Inlet
3
Figure 5. Typical UPS Installation (120V Model Shown)
