1. Situation:
In order to use one 4 channel remote to operate with additional device besides the original gate automation system.
Install a receiver box to connect with the 2nd device (such as another Powertech Slider)
or the 3rd device (Such as garage automation system)
Original gate automation: Using Button A & B (Pedestrian Mode) on the remote to control gate opener
2nd device: Install an external receiver box, connect output 1 to the 2nd device (such as another Slider, shown as
below) use button C on the same remote to control the 2nd device
3rd device: install an external receiver box, connect the output 2 to the 3rd device (such as garage door), use the
Button D now to operate.
2. Wire Connection:
a. After connect all necessary cables properly , press
Test Button to exam if the output 1 is working, the
gate opener should operate.
b. If Output 1 is functional, press and hold Learn Button
for 1 second, the LED light should be “ON”
* If the LED does not respond, please check the
cable connection again
c. Press and hold Button C on the remote for 1 second
after the LED is “ON”. The remote completed the
memorizing process when LED light turns “OFF”
3. Device Testing & Remote Memorization
a. Orange cable (Signal 1) connect to terminal 10 (Pb) on the control board
b. Blue cable (GND) connect to terminal 11 (GND) on the control board
c. Red cable (12V/24V ac/dc) connect to terminal 9 (Ph+) on the control board
d. Black cable (GND) connect to terminal 11 (GND) on the control board
PRB-1 Receiver
5.2 Wire Connection and Setting of PRB-1 External Reciever Box
Orange
Blue
Yellow
Green
Red
Black
-Signal 1
-GND
-Signal 2
-GND
-12V/24V
-GND
Output 1 (Normally Open Relay)
Output 2 (Normally Open Relay)
12V - 24V AC/DC
RB1 Receiver Box
Orange
Blue
Yellow
Green
Red
Black
-Signal 1
-GND
-Signal 2
-GND
-12V/24V
-GND
9
10
11
GND
Pb
Ph+
INSTRUCTIONS PL500 SLIDING GATE OPENER USER MANUAL
13
LED Light
Learn Button
Test Button
Output 1
Invalid Button
Invalid Button
