Powersmart PS8212, Инструкция по эксплуатации, Страница: 14 / 19

14
FITTING AND REPLACING LINE SPOOL ASSEMBLY
WARNING:
Disconnect appliance from power supply before performing adjustments. Only fit line
spool recommended by the manufacturer.
The line spool is already fit with the string trimmer when out of package. You need to replace it with
new line when it’s used up.
1.
Turn the line trimmer upside down so you have direct access to the spool.
2. Hold the bottom of the spool firm with one hand and with the other hand squeeze the tabs on either
side of the spool cover and remove the cover.
3. Remove the empty spool and clean out the spool cover.
4. Using a fully wound spool pass the line through the eyelet of the spool. Fit the spool of line into the
spool cover fully. Applying light pressure, rotate the spool of line until it locks in position.
5. Replace the spool cover ensuring the 2 clips locate and snap in place. Check the cover is secure.
6. Push the square button on the spool and at the same time, pull on the cutting line. Extend the line just
past the cutter on the guard.
CAUTION:
After changing the line spool, run the trimmer under no load for at least a minute to make sure
that the line and the tool are both operating correctly. Use only the line spool as recommended
by the manufacturer.