POWE50102
EN
Copyright © 2018 VARO
P a g e
|
10
www.varo.com
10.2
Connecting cable
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
11 TECHNICAL DATA
Nominal Voltage
220-240 V ~ 50 Hz
Power rating
1650 W
No load speed
5000 min-1
Protection class
II
Blade size
210 mm x 30 mm
12 CUTTING CAPACITY
Worktable tilting
angle
Head tilting angle
Height x width (mm)
90°
90°
60 x 170 mm
45°
90°
60 x 120 mm
90°
45°
34 x 170 mm
45°
45°
34 x 120 mm
13 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
90 dB(A)
Acoustic power level LwA
110 dB(A)
ATTENTION!
Wear
hearing
protection
when
sound
pressure
is
over 85 dB(A).
14 STORAGE
▪
Thoroughly clean the whole machine and its accessories.
▪
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place; avoid too high and too low temperatures.
▪
Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
▪
Don’t keep it in plastic bags to avoid humidity build-up.
15 TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Motor does not run.
No electricity arrives at the machine.
The motor is overloaded or
overheated.
Check the power supply and
the power line.
Allow the machine to run idle
for about 2 minutes to cool
down.
Vibrations are too
strong.
Screws or parts are loose.
The mitre saw is not correctly
mounted.
Work piece is not properly supported.
Tighten all screws.
Mount the mitre saw
correctly.
Secure the work piece.
