en 16
S
torage
• Remove lance from the gun and place in the accessory holder. Place the gun in the accessory
holder one the side. Lances are placed into any of the slots in the back of the unit. Make sure to
discard any remaining detergent from the tank. Flush the tank and nozzle head with fresh water
to prevent clogging.
• When your pressure washing session has been completed, turn off the power switch located on
the front of the power washer. Unplug the power cord from the outlet. Turn off the water supply.
Pull the trigger on the spray gun 2-3 times to drain out the excess water and to release any
remaining water pressure. Disconnect the garden hose adapter from the water inlet. Do not allow
the power washer to run with no water flowing through it.
• Remove detergent tank and clean completely. Residual chemical will stick to the container and
can cause the detergent injector to clock and not function properly.
• Remove high pressure hose from spray gun and unscrew the other end of the high pressure hose
from the power washer.
• Wrap the power cord around the L-shaped tabs on the right side of the machine when facing it.
• The pressure hose is stored on the hose hook located on the back of the handle.
• DO NOT store the power washer where it is exposed to freezing temperatures unless
you use Pump Saver.
It is recommended that you use Pump Saver for storing in freezing
temperatures. Freezing will damage the pump unless Pump Saver is added to the power washer.
If not using or if storing your power washer for more than one month, run Pump Saver through it.
See the section on Pump Saver for more information.
