en 14
H
oW
t
o
c
Lean
Cleaning nozzles
•
A clogged or partially clogged nozzle can cause significant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while spraying.
• Turn off the unit
• Turn off the water supply to the unit
• Relieve any pressure trapped in the hose by squeezing the trigger 2-3 times, and then lock the
spray gun by pushing the lock button from left to right.
• The screens inside the adapter should be cleaned periodically. Rinse it with clean water, and then
place it back in the adapter.
• Using the nozzle tip cleaner provided (or an unfolded paper clip), insert the wire into the nozzle
hole and move back and forth until debris is dislodged
(Fig. 23)
. Back flush water through the
nozzles using garden hose and highest pressure available (either standard water nozzle or use
your thumb over the nozzle to create water pressure for back flush).
o
Perating
t
iPS
and
m
aintenance
• If you hear the motor run intermittently when the trigger is not being squeezed, that is normal. The
pump is priming itself so it is ready to operate when the trigger is squeezed. Turn off the power
washer if not being used after five minutes.
• The o-rings on the bayonet end of the lance should be cleaned regularly and lubricated with non-
water soluble grease such as petroleum jelly.
• Keep the nozzle cleaning wire, Which is taped to this manual for use in unclogging the lance
nozzle. If you lose the cleaning wire an unbent paper clip works fine.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because the impact force of the water pressure
exceeds the durability of the surface. Bare wood can be penetrated; paint can be peeled off, etc.
You can vary the force of your power washer by controlling:
a. the angle of the surface being cleaned
b. the distance of the nozzle from the surface being cleaned
Fig. 23
