SAFETY INSTRUCTIONS
3
When operating this Stapler, the operator and others in the work area should ALWAYS wear approved
SAFETY GLASSES, with FRONT and SIDE eye protection. Eye protection will help guard against
fl ying nails and debris, which could cause severe eye injury.
EAR PROTECTION should be used to prevent hearing damage when there are high noise levels in
the work area. ALWAYS use ear plugs with a noise reduction rated at 29 db or higher at a construction
site.
Stapler noise ratings are at LPA-1sd=90.6,
LWA-1sd=99.3 and LPA-1s,1m=86.3.
Stapler vibration rating: m/s2=3.05.
Always DISCONNECT THE AIR SUPPLY before making any adjustments, repairing, clearing jams or when
the Stapler is not in use. Do not use on scaffolding or ladders and disconnect Stapler from air supply when
transporting between installation areas.
Never attach the female end of a quick disconnect to the Stapler. This will trap air inside the Stapler and permit it
to be discharged. Only the unrestricted male connection should be attached to the Stapler.
Stapler requires an air source that can continuously deliver 70 to 110 psi at 3-1/2 cubic feet of air per minute for
operation.
Normal air pressure should not exceed 110 psi or damage to the Stapler and seals may occur. Excess air
pressure can cause the Stapler to explode.
To prevent fi re or explosion, use only regulated compressed air—do not use bottled gases of any kind (no
oxygen or combustible gasses) to power this Stapler.
Stapler is intended for use installing wood fl ooring and is not to be used for purposes not specifi ed in the
operations manual.
Do not use any staples other than Powernail® Powerstaples which are specifi cally designed for use in any
Powerstapler. Powercleats Staples are available in various lengths. Contact your Powernail Dealer for
Powernail Staples.
Use only Powernail replacement parts in the repair or maintenance of this Stapler. Parts or repair services are
available from the manufacturer or from agents authorized by the manufacturer. Repairs should be carried out
only by trained service personel in the fi eld of fastener driving tools who will observe proper safety controls while
performing maintenance. Service personel should be qualifi ed to assess the safe working condition of fastener
driving tools.
Always make sure Stapler is empty of nails before connecting air hose, so as to prevent any accidental
discharge from occurring. ONLY CONNECT AIR TO AN UNLOADED Stapler.
Do not depress the trigger when loading. If the fasteners are jammed, disconnect the tool from the air supply
before you remove the jammed nails.
Never place any part of the body in the discharge path of the Stapler when air is connected to the
Stapler. Never point the tool at yourself or others, even if the tool is not loaded. For safety, keep out of
reach of children. Never leave the Stapler unattended while it is connected to an air supply.
Do not fi re into hard materials or attempt to use on hard or brittle material such as concrete, steel or tile. Before
using this tool, carefully check that all parts are working correctly. Do not use the tool if it is not operating
correctly, check for causes and adjust as necessary for proper operation. When not in use, the tool should be
cleaned, fully assembled and then stored in a dry location. This will extend the life of the tool and reduce any
oxidation.