www.powermaxfitness.net
19
Warning:
Make sure power plug disconnect before moving motor cover away, clean the motor at
least once a year.
Running belt specialized lubricant
This electric treadmill’s running board and running belt has been lubricated in factory. Friction
between the running belt and running board has a great influence to the using life and the
performance of the electric treadmill, therefore regular applying of lubricant is needed. We advise
you to check the board regularly. If the board’s surface is damaged, please contact our customer
service centre.
We advise using lubricant between running belt and running board with following schedule:
Lightweight user (use less than 3 hours a week): once per month. Open the motor cover, check
and make sure the oil is no less than 30ml. If it’s less than 30ml, please refill it to 90
ml (no more
than 90ml).
Heavyweight use (use more than 7 hours a week) once every two months. Open the motor cover,
check and mak
e sure the oil is no less than 30ml. If it’s less than 30ml, please refill it to 90
ml (no
more than 90ml).
1.
In order to better safeguard your electric treadmill and extend the life of the machine, it is
recommended that after continued use of two hours, turn off the machine and let it rest
for 10 minutes before using again.
2.
If the treadmill belt is too loose, there will be skid
phenomenon’s
while running; if it’s
too tight, it may reduce motor performance and harden the abrasion of roller and the
running belt. You can lift two sides of the running belt for 50-75mm when the tightness is
appropriate.
Running with adjusted alignment and tightness
In order to better use the treadmill and make the treadmill functions work better, it is necessary
for you to adjust the running belt into the best condition.
Running Belt alignment
•
Put electric treadmill on the flat ground.
•
Make the electric treadmill run at a speed of about 6-8km/h.
•
If the running belt is closer to the right, rotate the right adjusting bolt with 1/2 turn
clockwise, then rotate the left adjusting bolt with 1/2 turn counter-clockwise. (Picture B)
•
If the running belt is closer to the left, rotate the left adjusting bolt with 1/2 turn clockwise,
then rotate the right adjusting bolt with 1/2 turn counter-clockwise. (Picture A)
