Powermatic PM2820EVS, Инструкция по эксплуатации и каталог запасных частей

Страница: 2 / 36

2
1.0 IMPORTANT SAFETY
INSTRUCTIONS
Warning – To reduce risk of injury:
1. Read and understand the entire owner's
manual before attempting assembly or
operation.
2. Read and understand the warnings posted on
the machine and in this manual. Failure to
comply with all of these warnings may cause
serious injury.
3. Replace the warning labels if they become
obscured or removed.
4. This drill press is designed and intended for use
by properly trained and experienced personnel
only. If you are not familiar with the proper and
safe operation of a drill press, do not use until
proper training and knowledge have been
obtained.
5. Do not use this drill press for other than its
intended use. If used for other purposes,
Powermatic disclaims any real or implied
warranty and holds itself harmless from any
injury that may result from that use.
6. Always wear approved safety glasses/face
shields while using machine. Everyday
eyeglasses only have impact resistant lenses;
they are not safety glasses.
7. Before operating this drill press, remove tie,
rings, watches and other jewelry, and roll
sleeves up past the elbows. Remove all loose
clothing and confine long hair. Non-slip
footwear or anti-skid floor strips are
recommended. Do not wear gloves.
8. Wear ear protectors (plugs or muffs) during
extended periods of operation
9. Do not operate this machine while tired or under
the influence of drugs, alcohol or any
medication.
10. Make certain the switch is in the OFF position
before connecting the machine to the power
supply.
11. Make certain the machine is properly grounded.
12. Make all machine adjustments or maintenance
with the machine unplugged from the power
source.
13. Remove adjusting keys and wrenches. Form a
habit of checking to see that keys and adjusting
wrenches are removed from the machine
before turning it on.
14. Keep safety guards in place at all times when
the machine is in use. If removed for
maintenance purposes, use extreme caution
and replace the guards immediately after
completion of maintenance.
15. Check damaged parts. Before further use of the
machine, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended
function. Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or
replaced.
16. Provide for adequate space surrounding work
area and non-glare, overhead lighting.
17. Keep the floor around the machine clean and
free of scrap material, oil and grease.
18. Keep visitors a safe distance from the work
area. Keep children away .
19. Make your workshop child proof with padlocks,
master switches or by removing starter keys.
20. Give your work undivided attention. Looking
around, carrying on a conversation and “horse-
play” are careless acts that can result in serious
injury.
21. Maintain a balanced stance at all times so that
you do not fall into the blade or other moving
parts. Do not overreach or use excessive force
to perform any machine operation.
22. Use the right tool at the correct speed and feed
rate. Do not force a tool or attachment to do a
job for which it was not designed. The right tool
will do the job better and more safely.
23. Use recommended accessories; improper
accessories may be hazardous.
24. Maintain tools with care. Keep drill bits sharp
and clean for the best and safest performance.
Follow instructions for lubricating and changing
accessories.
25. Turn off machine and disconnect from power
before cleaning. Use a brush to remove chips
or debris — do not use bare hands.
26. Do not stand on the machine. Serious injury
could occur if the machine tips over.
27. Never leave machine running unattended. Turn
the power off and do not leave the machine until
spindle comes to a complete stop.
28. Remove loose items and unnecessary work
pieces from the area before starting the
machine.