8
Handles
1. Remove
the
plate
(Y) from the
handle
(X) by
loosening the two
socket head cap screws
(Z)
with a 6mm hex wrench.
2.
Install
handle
(X) to the holes in the
collector
housing
(U) by inserting the socket head cap
screws through the handle, the collector
housing, and into the plate on the opposite side.
Tighten the screws.
Note:
Make sure the
plate
(Y) is oriented
properly, as shown in the Detail in Figure 3: The
protrusions on the plate should face away from
the handle.
3. Install the other three handles in like manner.
(Two handles for each housing.)
Cone Installation
Install the cone assembly as shown in Figure 3a.
1. Mount the cone support bracket (AA) to the
housing with four M6x12 hex cap screws (FF)
and tighten from beneath with four M6 hex nuts
(GG).
2. Install the cone (BB) from beneath using the
M8x16 hex cap screw (CC), M8 flat washer
(DD) and M8 hex nut (EE).
Filter System
If your PM1900TX Dust Collection system includes
filter bags, proceed to
Filter Bag System Assembly
on
page 9.
If your PM1900TX Dust Collection system includes
the canister kit, proceed to
Canister System Assembly
on page 10.
Figure 3: Assembly and part identification
