Powermatic DS20, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 20

10
Adjustments
Table Movement
The work table (A, Figure 6) can be tilted 30
degrees forward and 45 degrees backward.
1. Loosen the handle (B, Figure 6) and rotate
the handwheel (C, Figure 6) clockwise to tilt
table backward, and counterclockwise to tilt
table forward. The pointer on the trunnio n
scale (D, Figure 6) indicates the angle.
2. When table is positioned, re-tighten handle
(B, Figure 6).
The table can also be raised or lowered on the
column:
1. Loosen the lock handle (E, Figure 7) and
adjust the table height by rotating the
handwheel (F, Figure 7); clockwise to lower
the table, counterclockwise to raise it.
2. When finished, re-tighten lock handle (E,
Figure 7).
Squaring the Table
1. Verify the accuracy of the scale pointer by
positioning the table in horizontal position,
and placing a square on the table and flus h
against the disc. (It is easier to do this
without an abrasive disc attached.) See
Figure 8.
2. Adjust the table until the square is flus h
against both surfaces.
3. If required, adjust the pointer to the zero
mark, and retighten the screw.
Replacing Abrasive Disc
The DS20 takes standard 20” diameter cloth or
paper-back sanding discs. We recommend 60
grit for coarse or rough sanding, 80 grit for
general purpose medium duty sanding, and 100
grit for fine sanding.
1. Lower the table as far as possible, and pus h
back the guard. See Figure 6.
2. Use a putty knife to remove the old abrasive
from the disc. Clean the disc with solvent
and allow it to dry.
3. Mount the new sanding paper. Sanding
paper is available in various forms, such as
adhesive backed discs and pressure-
sensitive discs.
4. Raise the table, and pull the guard back
over the disc before operating the sander.
Figure 6
Figure 7
Figure 8