Powermatic 15S, Руководство пользователя

Страница: 11 / 48

11
STARTER BOX
Mount the controls as shown in Fig. 8, with the
two socket head cap screws which you’ll find
mounted to the head casting. Use a 5mm hex
wrench.
EXTENSION TABLES
1. Mount a cast iron table to the edge of the
main table with three M8 x 25 hex cap
screws (Fig. 9) using a 12mm wrench. Do
not fully tighten yet.
2.
The extension table must be leveled with the
main table. Place a straight edge (such as a
jointed board) across the extension table and
the main table.
NOTE: The straight edge should not lie over
the raised table rollers, as this would distort
the leveling process. Either place the straight
edge just short of the table rollers, or lower
the table rollers completely into the table
(see page 14) while mounting the extension
tables.
3.
Insert three socket set screws with a 4mm
hex wrench, and screw them in or out as
needed until tables are level.
4.
Securely tighten the hex cap screws.
5. Mount the second extension table to the
opposite side of the planer table, using the
same procedure.
DUST HOOD
Mount the hood to the rear of the head casting
with three M6 x 12 socket head cap screws with
lock washers, and three M5 x 10 hex cap screws
with flat washers. See Fig. 10.
It is recommended that you use a dust collection
system with this planer. If you are not using a dust
collection system, do not attach the dust hood to
the planer, as the accumulation of dust inside the
hood may create a safety hazard, or eventually
cause jamming of the rollers.