Saddle Bolts
Saddle Bolts
Handle Knobs
Handle Knobs
Figure 3
Figure 4a
Figure 4b
Figure 2
INSTALL THE WHEELS
(See Figure 2)
1. Slide the wheel hub onto the wheel axle.
2. Install M8 x 20mm bolt with 30 mm flat washer.
ATTACH UPPER HANDLE
(See Figure 3)
1. Slide the upper handle down over the lower handle and
align the holes.
2. Insert the saddle bolts into the holes as shown and
securely with the handle knobs.
3. Tighten the handle knobs securely.
8
Assembly Instructions
B
Assembly
(Continued)
• Save all instructions
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
INSTALL THE DRAG BAR
(See Figure 4a and 4b)
1. Remove the bolt and knob from the depth regulator lever.
2. Insert the drag bar into the bottom of the swing plate
bracket.
3. Insert the detent pin thru the bracket and drag bar.
The tiller comes fully assembled except for a few parts. The following instructions will help you complete the tiller assembly.
Questions? Call Toll Free at 1-800-737-2112
Copyright © 2011 MAT Engine Technologies, LLC
