5
Overload can cause overheating:
Do not extend the cycle of welding, welding between cycles allow
Overload can cause overheating:
Do not extend the cycle of welding, welding between cycles allow
the device to cool. In the case of excessive heating of the device, shorten the cycle time of welding or
reduce the welding current.
STATIC DISCHARGE MAY DAMAGE THE PRINTED CIRCUIT:
Before touching the printed circuit
STATIC DISCHARGE MAY DAMAGE THE PRINTED CIRCUIT:
Before touching the printed circuit
boards and parts of the electrical system should be assumed grounding wrist-strap. Use of antistatic
packaging is storing and transporting electrical components.
READ INSTRUCTIONS:
Carefully read the manual and follow the information contained therein. For
READ INSTRUCTIONS:
Carefully read the manual and follow the information contained therein. For
any damage caused by failure to comply with the guidelines of this manual manufacturer is not
liable.
HIGH RADIATION
FREQUENCY:
high radiation
frequency radio signal can zakłucać, alarm systems, work computers and communications
equipment. User is obliged to ensure a qualified electrician correct the problems resulting from
zakłucenia electrical installation. Regularly check and maintain electrical installations. Use
grounding, shielding and anti-surge protection measures to minimize any zakłucenia.
ARC WELDING CAN CAUSE ZAKŁUCENIA:
Electromagnetic energy can interfere with electronic
ARC WELDING CAN CAUSE ZAKŁUCENIA:
Electromagnetic energy can interfere with electronic
equipment such as computers and computer-controlled equipment. Make sure that the hardware
devices in the work environment welders are electromagnetically compatible. To minimize the
potential for interference stick welding wires close to each other, as close to the ground. IN
If electrical noise sensitive spot welding should not be closer than 100m. The device must be connected and
grounded in accordance with this instruction. If noise still persists the user needs to take additional measures such as
changing jobs, the use of shielded cables, filters, linear and securing jobs.
Electromagnetic field
To reduce the amount of electromagnetic fields in the workplace include:
1. Keep cables close together (you can turn the tape or taped).
1. Keep cables close together (you can turn the tape or taped).
2. Organize the wires from one side of the operator as far as possible from him.
2. Organize the wires from one side of the operator as far as possible from him.
3. Do not wrap the cables around the body.
3. Do not wrap the cables around the body.
4. The power source and wires should be as far away from the operator as possible.
4. The power source and wires should be as far away from the operator as possible.
5. Connect the terminal welding seam as close as possible.
5. Connect the terminal welding seam as close as possible.
pacemakers
You should consult your doctor before welding and welding being in place. The doctor will explain the procedure if
any of the contact with the welding apparatus.
